How to Configure WiFi Connection for Original JLR DoIP VCI

Original Jaguar Land Rover diagnostic tool JLR DoIP VCI supports both USB and WiFi connection. Here’s the guide to configure the LAN setting.
Procedure:
Connect JLR DoIP VCI W-F interface with vehicle
Connect the other end of VCI with laptop via USB cable

Open VCI Manager (JLR), press Connect

Choose Network Setup tab->Wired Etherent

Tick Enable Wired Etherent Interface

Press Apply button and Yes

Then disconnect USB connection
Close VCI Manager
Open VCI Manager again
Press Connect
Go to Network Setup->Wired Etherent
Press Set Factory Default

Press OK if system prompts you are about to reset the VCI communication settings to a factory default state.

Enable network connection
Press Set Factory Default again

In Wireless (802.11), choose Obtain an IP address automatically, then press Access Point

Choose Wireless resource which is the same as the your network
Press Configure

Enter wireless security password (encryption key)
Press Next

JLR VCI is configured to connect to your network
Disconnect and then Connect VCI

It shows WiFi connection is done
Open JLR SDD software on desktop

Press Connect

Now you can run SDD software for diagnosis